Free U.S. Shipping & Lifetime Warranty For All Endura Flap Pet Doors

Endura Flap Cat Door for Horizontal Sliding Windows - Installation Instructions

Installation Instructions

Installation icon Printable Version
Installation icon Difficulty Easy
Installation icon Steps 04
Installation icon Time Required 0.5 hours
Installation icon Sections 02
Installation icon Flags 02

Parts

  • 1 Horizontal Window Pet Door
  • 1 Foam Weather Strip
  • 1 Center Post Weather Seal Draft Stopper
  • 1 Clamp Lock
  • Screwdriver

Tools

  • Scissors
  • Flathead Screwdriver

Please read instructions & notes thoroughly before installation.

Step 1 Release Spring Mechanism

  • Loosen the height adjustment locks at the top of the pet panel with the screwdriver. This allows the spring mechanism to move freely up and down.

Step 2 Check Panel Fit

insert panel into track
  • To insert the panel into the top track, push up against the spring mechanism and swing the bottom of the panel up and over the threshold. Seat the panel on top of the small guide rail in the track.
  • You want to put the pet door in your track before applying any weather-stripping to ensure it fits.
  • If the panel fits well, proceed to the next step. See the FAQs if you have trouble.

Step 3 Apply Weather-stripping

apply weather stripping to panel
  • Once you’re sure the panel fits, remove it from the frame and lay it on its side on the ground.
  • Apply the foam weather-stripping by peeling back the paper and exposing the adhesive. Unroll it along the edge of the panel, pressing to ensure it adheres. Install on both sides, trim to fit with scissors.

Step 4 Install Center Post Weather Seal

apply center post weather seal fig a
apply center post weather seal fig a
apply center post weather seal fig b
  • The center post weather seal strip (draft stopper) should be installed on the inside of the home. It can be installed on either the back edge of the sliding window panel (Figure A) or the leading edge of the stationary panel (Figure B).
  • This strip prevents air from leaking between the sliding window and the stationary panel. Trim with scissors as needed.
  • Clean the edge of your window with rubbing alcohol before installing to assure a good seal.
  • Place the panel back into the window, then tighten the height adjustment locks to lock it in place. Installation complete!